Error code · Dryer

ASKO Tumble Dryer Code E6: A Control Switch Did Not Respond

Medium · inspection needed

Code: E6
Appliance: Dryer
Brand: ASKO
Warranty: 30-day workmanship

What E6 means

An E6 on an ASKO T5 series tumble dryer (TD86 platform, such as the T5HXLW.U), is a relay error that the manufacturer groups under control unit problems. A relay is an electronic switch on the control that turns power to the heater, motor or other parts on and off. E6 means one of those switches did not act the way the control commanded, which ends the cycle and brings up the code.

Common causes of E6

A relay on the main control not switching as commanded
The control unit electronics that drive the relay
A passing glitch that a restart clears

✓ One safe check you can try

1. Switch the dryer off, give it a minute, then switch it back on. 2. Hold the OK button while E6 shows to read the description. 3. Start a short program to see whether the code returns. 4. If it does, leave the dryer off and schedule service.

! Why to stop there

Which relay on the control is involved
Whether the control can be repaired or needs replacing
Whether the part is in stock or has to be ordered, which we tell you up front

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

Protection enabled (screen lock)ASKO T5 Dryer Message "Protection Enabled (Screen Lock)" SENSORASKO T761 and T781 Dryer Message "Sensor" THERMISTORASKO T761, T781 and TD70 Dryer Message "Thermistor" F29ASKO TD70.1 Heat-Pump Dryer Code F29: Evaporator Needs Cleaning F3ASKO T731 Dryer Code F3: Thermistor Problem F30ASKO TD70.1 Dryer Code F30: Cycle Ran Over 200 Minutes F4ASKO T731 Dryer Code F4: Overheat Protection Tripped F5ASKO T731 Dryer Code F5: Moisture Sensor Reading

E6E6 questions

What is a relay on a dryer?

It is a small electronic switch on the main control. It turns power on and off to parts like the heater and motor. E6 means a switch did not respond properly.

Is E6 the same as E0?

They are related. Both point to the control unit, but E6 names the relay switching specifically, while E0 is a general control unit problem. We test the control to tell which one your dryer has.

Can you replace a dryer control?

Yes, when testing shows it is needed. To schedule service, call us or fill out the online form. A written price comes before any work, and the repair has a 30-day workmanship warranty.

Book a visit

Still seeing E6?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 804-6320