Error code · Dryer

ASKO TD70.1 Dryer Code F30: Cycle Ran Over 200 Minutes

On TD70.1 condenser and heat-pump dryers from ASKO that have the type B LCD panel, such as the T743C and T753C, F30 tells you the program ran longer than 200 minutes. The dryer then stops the…

Medium · inspection needed

(713) 804-6320

Code: F30
Appliance: Dryer
Brand: ASKO
Warranty: 30-day workmanship

What F30 means

On TD70.1 condenser and heat-pump dryers from ASKO that have the type B LCD panel, such as the T743C and T753C, F30 tells you the program ran longer than 200 minutes. The dryer then stops the cycle and resets the program. The usual reasons are poor condensation, meaning the moisture is not being removed from the air well, or blocked airflow where the dryer takes in outside air.

Common causes of F30

A load that came in too wet, such as clothes with a low spin speed
Poor ventilation in the room
Lint restricting the airflow or condensation
Whether the dryer repeats F30 with a lightly loaded drum

✓ One safe check you can try

1. Turn the dryer off at the main switch and leave it off for about 30 minutes before restarting. 2. Make sure the room is well ventilated while the dryer runs. 3. Spin laundry at a higher speed in the washer before drying. 4. If F30 repeats, schedule service.

! Why to stop there

Whether the condenser or heat-pump circuit is removing moisture as it should
Whether lint or a restriction is slowing the airflow
Whether an ordinary load finishes drying well under the limit

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

Protection enabled (screen lock)ASKO T5 Dryer Message "Protection Enabled (Screen Lock)" SENSORASKO T761 and T781 Dryer Message "Sensor" THERMISTORASKO T761, T781 and TD70 Dryer Message "Thermistor" F5ASKO T731 Dryer Code F5: Moisture Sensor Reading It is necessary to clean the drumASKO T5 Dryer Message "It Is Necessary to Clean the Drum" MAXIMUM PROGRAM TIMEASKO T761 and TD70.2 Dryer Message "Maximum Program Time" NO ERROR CODESASKO T711 and T721 Dryers: No Error Codes in the Manual OVERFLOWASKO T781 and TD70.3 Dryer Message "Overflow"

F30F30 questions

Why does the dryer stop at 200 minutes?

The control cuts off any program that runs past that time, because a cycle that long means the dryer is not drying efficiently. It then resets the program and shows F30.

Does a wetter load cause F30?

It can. Clothes that come out of the washer very wet take much longer to dry. A higher spin speed in the washer is a free first step.

Is an older TD70.1 worth repairing?

Often it is, though we are honest when a repair is not worth the money. We repair dryers like this regularly. To schedule service, call us or use the online form. The price goes in writing before we start, and a 30-day workmanship warranty follows the repair.

Book a visit

Still seeing F30?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 804-6320