Error code · Dryer

ASKO Dryer Code E0: Problem in the Control Unit

High · stop use, call now

Code: E0
Appliance: Dryer
Brand: ASKO
Warranty: 30-day workmanship

What E0 means

On ASKO T5 series tumble dryers (TD86 platform, with the T5HXLW.U among them), the display reports problems as the letter E followed by a number. An E0 means the control unit, the electronic brain of the dryer, has detected a problem in its own operation. The drying program stops and the screen shows the code in place of the cycle. Holding the OK button while the error is on screen brings up a short description.

Common causes of E0

The control unit's own circuits reporting a problem
A one-time electronic glitch that a power-off restart clears
Whether the same error returns as soon as the dryer starts again

✓ One safe check you can try

1. Use the control to turn the dryer off, wait briefly, then turn it on again. 2. If E0 appears, hold the OK button to read the description on the display. 3. Close the door, select a short program, and see whether the error returns. 4. If it does, stop using the dryer and arrange a repair visit. Do not open any panels yourself.

! Why to stop there

Whether E0 was a single glitch or a control unit that keeps failing
Whether the problem sits in the control unit itself or in the wiring that feeds it
Which control part your dryer needs, which we confirm before quoting

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

Protection enabled (screen lock)ASKO T5 Dryer Message "Protection Enabled (Screen Lock)" SENSORASKO T761 and T781 Dryer Message "Sensor" THERMISTORASKO T761, T781 and TD70 Dryer Message "Thermistor" F5ASKO T731 Dryer Code F5: Moisture Sensor Reading It is necessary to clean the drumASKO T5 Dryer Message "It Is Necessary to Clean the Drum" MAXIMUM PROGRAM TIMEASKO T761 and TD70.2 Dryer Message "Maximum Program Time" NO ERROR CODESASKO T711 and T721 Dryers: No Error Codes in the Manual E3ASKO Dryer Code E3: Pump Not Moving Condensate

E0E0 questions

What is E0 telling me on my T5 dryer?

It tells you the control unit found a problem in its own operation. The dryer cannot trust its own electronics, so it stops the cycle and shows the error until it is restarted or repaired.

Is it safe to turn the dryer off and on?

Yes. Turning the dryer off and on again is the first step in the owner's manual, and holding OK shows the description. If E0 comes back after the restart, stop using the dryer and have it checked.

Do you repair this dryer?

Yes. To schedule service, call us or fill out the online form. A written price comes before any work, and the repair has a 30-day workmanship warranty.

Book a visit

Still seeing E0?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 804-6320