Error code · Washer

ASKO Washer Message “FOAMING”: Too Much Suds

When an older ASKO W6641 or W6661 washer with the LCD text display prints FOAMING, there are too many suds in the drum for the washer to rinse and drain properly. The message points to the…

Low risk · DIY check OK

(713) 804-6320

Code: FOAMING
Appliance: Washer
Brand: ASKO
Warranty: 30-day workmanship

What FOAMING means

When an older ASKO W6641 or W6661 washer with the LCD text display prints FOAMING, there are too many suds in the drum for the washer to rinse and drain properly. The message points to the amount of detergent or softener, not to a broken part. Many homes still use these older washers, and we repair them when the message keeps returning.

Common causes of FOAMING

Detergent or softener dose that is larger than the load needs
Detergent that makes heavy suds in a front-loading washer
Soap and softener left from earlier loads

✓ One safe check you can try

1. Run the Rinse program again. 2. For the next load, use less detergent and less softener. 3. Switch to a low-sudsing detergent made for front-loading washers. 4. Turn the power off or change the program to clear the message.

! Why to stop there

If FOAMING comes back with a small dose of low-sudsing detergent, we test the water level sensor and the drain path
Foam can hide a slow drain, so we watch a full draining cycle before we decide nothing is wrong
Because the W6641 and W6661 are older, we confirm any part first and say plainly if a repair is not worth it

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

E7.2ASKO W5 Washer Shows E7.2: Too Much Detergent E9 / E9.1ASKO W5 Washer Code E9 or E9.1: Water Leak Detected F10ASKO W6 Washer Error F10: Overfilling F11ASKO W6 Washer Code F11: Drainage Error F12ASKO W6 Washer F12: Water Inlet Error OVERFLOWASKO Washer Message "OVERFLOW": Water Level Too High PRESSURE SENSOR FAULTASKO Washer Message "PRESSURE SENSOR FAULT": Water Level Sensor Problem TEMPERATURE STOP FAULTASKO Washer Message "TEMPERATURE STOP FAULT": Temperature Control Problem

FOAMINGFOAMING questions

What does FOAMING mean on my ASKO washer?

The drum holds too many suds. Foam slows rinsing and can keep the pump from clearing water, so the washer stops and shows the message until you change the program or turn the power off.

How do I get rid of the foam?

Run the Rinse program again. The owner's manual then asks you to use less detergent and softener, and a low-sudsing detergent works best.

Does FOAMING mean the washer is broken?

Usually not. It is a reminder about the detergent amount. If the message returns with small doses, we check the sensors and the drain, with a written price before any work.

Book a visit

Still unsure about FOAMING?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 804-6320